Oil-water interface instrument manufacturers share their products how to use

　　Oil-water interface instrument is a kind of high precision testing equipment, which can accurately measure the position of oil-water interface in liquid. It is very simple to use, just follow the steps below to operate. Here is a look at the oil water interface instrument manufacturers to share their products how to use.

　　Before using an oil-water interface instrument, a simple preparation of the equipment is required. First, verify that the device is intact and connected, and determine whether the battery has been installed. In addition, the liquid surface is cleaned to ensure that the test area is free of impurities to ensure the accuracy of the test results.

　　1. Turn on the power switch of the oil-water interface instrument and place the probe stably on the surface of the liquid to be measured.

　　Note: When placing the probe on a liquid surface, ensure that the probe is perpendicular to the horizontal plane.

　　2. Press the measuring key on the instrument, while the probe is working, the liquid crystal display will display the position of the liquid oil and water interface.

　　Note: The probe should not be placed for too long, generally about 3 to 5 seconds.

　　3. If you need to measure again, just press the "Reset" button to reset the instrument and measure again.

　　4. After the measurement is completed, turn off the power switch and properly store the oil-water interface instrument in a safe location for future use.

Read recommendations:

mini circuits power splitter

coax locking terminator

rf microwave filters

Research on the Stability of Fixed - Value Coaxial Terminals

coax termination block.What is the function of an RF synthesizer?